Effect of W additions to Ti-48Al-2Nb-2Cr alloys
Clicks: 263
ID: 271403
1995
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
263 views
32 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #2 of 6 articles by views in materials science and engineering: a
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Alloying additions of 0, 0.5 and 1.0 at.% W were made to Ti-48Al-2Nb-2Cr alloys for increased strength and creep resistance. The alloys were processed by both ingot metallurgy (IM) and powder metallurgy (PM) routes. Duplex and near-lamellar microstructures were produced by heat treatment. The tensile properties of the materials were examined in the temperature range 25–1000 °C in air. The creep properties were determined at 850 °C at stresses ranging from 103 to 207 MPa. The interrelationship between composition, microstructure, processing and properties are discussed.
| Reference Key |
fuchs1995materialseffect
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | G.E. Fuchs;G.E. Fuchs; |
| Journal | materials science and engineering: a |
| Year | 1995 |
| DOI |
10.1016/0921-5093(94)03291-2
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.