Laboratory Validation of Surface-Initiated Transverse Cracking of Asphalt Pavement

Clicks: 154
ID: 269666
2020
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #162 of 187 articles by views in applied sciences

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 187 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Field pavement transverse cracking typically can be grouped into two categories, namely thermal cracking that initiates at the surface of the pavement and propagates downward, and reflective cracking that initiates at the pavement layer above the existing pavement cracks or joints and propagates upward. Recently, another transverse cracking phenomenon was noticed in some field investigations but was less studied. Cracks were observed from both the surface and the bottom of field cores, but they cannot be visually observed from the middle layer. In addition, the surface and the bottom cracks lined up well, showing the tendency of meeting each other. This study aimed to evaluate the causes of such transverse cracking phenomena by laboratory tests. Hamburg equipment was used as the evaluation equipment. Some samples were prepared with a saw cut notch 0.33 inches in depth and 0.25 inches in width, and some samples were prepared without the notch at the bottom. The results showed that such a crack type could have happened when samples are aged, the base below the sample is soft, and a notch exists in the bottom layer. A potential mechanism is when the wheel load moves on one side of the existing transverse cracking (the near side), as the specimen on this side tends to bend downward under the wheel load, especially when the support is relatively soft. If without constraint, the other side of the specimen (the far side) should consequently be tilted upward. However, the bonding with the base layer and the self-weight of the specimen restrict the upward movement of the far-side specimen. Therefore, the tensile stress at the surface of the specimen directly on top of the bottom crack is created. At the same time, the bottom crack has the potential of being squeezed and pushed together.
Reference Key
zhang2020appliedlaboratory Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Weiguang Zhang;Ali Raza Khan;Shihui Shen;Yingda Gao;Zhang, Weiguang;Khan, Ali Raza;Shen, Shihui;Gao, Yingda;
Journal applied sciences
Year 2020
DOI
10.3390/app10031002
URL
https://www.mdpi.com/2076-3417/10/3/1002
Keywords
aging surface-initiated transverse cracking laboratory evaluation soft base existing joint

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.