Mechanical Clinching and Self-Pierce Riveting of Thin Three Sheets of 5000 Series Aluminium Alloy and 980 MPa Grade Cold Rolled Ultra-High Strength Steel.

Clicks: 250
ID: 261309
2020
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #498 of 812 articles by views in Materials (Basel, Switzerland)

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 812 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
One thin 5000 series aluminium alloy sheet and two thin 980 MPa grade cold rolled ultra-high strength steel sheets were joined by self-pierce riveting and mechanical clinching processes. The joinabilities for a combination of the aluminium and steel sheets in both processes were investigated for different die shapes in the experiment and finite element simulation. In self-pierce riveting, the three sheets were successfully joined for both combinations of the upper and lower aluminium alloy sheets by optimizing the shapes of a die and rivet. In mechanical clinching, the three sheets were successfully joined by an optimum die for the configuration of the upper aluminium alloy sheet. On the other hand, the three sheets for the configuration of the lower aluminium alloy sheet were not joined even by optimizing the die shape in the both finite element simulation and experiment, because the material flow of the steel sheets was insufficient to form the two interlocks. The tension-shear loads for the clinched and riveted sheets with the adhesive were almost the same, because the load for the adhesive was the highest. In the cross-tension test, however, the load by the adhesive was comparatively small.
Reference Key
abe2020mechanicalmaterials Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Abe, Yohei;Maeda, Takato;Yoshioka, Daiki;Mori, Ken-Ichiro;
Journal Materials (Basel, Switzerland)
Year 2020
DOI
E4741
URL
Keywords
plastic deformation joining aluminium alloy sheet joint strength mechanical clinching self-pierce riveting three sheet ultra-high strength steel sheets

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.