preparation and anticorrosion of octadecyl trichlorosilane sams for copper surface
Clicks: 124
ID: 254291
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
124 views
31 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #38 of 38 articles by views in Pesticide biochemistry and physiology
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The self-assembled monolayer (SAM) was prepared using octadecyl trichlorosilane (OTS) in distilled solution on the copper surface. The effect of inhibitor concentration on the rate of inhibition efficiency and corrosion rate in corrosion medium on copper by using polarization curves, electrochemical impedance spectroscopy (EIS), scanning electron microscope (SEM) was studied. The results showed that OTS SAMs exhibit the better corrosion resistance; the corrosion potential of copper OTS SAMs protection increased by about 1.02 V, while the corrosion current density decreased to 0.59 μA/cm2. The corrosion rate is minimized and flattened and can reach 9.2% while the inhibition efficiency reached 95.4%, when the corrosion inhibitor has concentration of 40 ppm.
| Reference Key |
shouqing2017internationalpreparation
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Xue Shouqing;Liu Xiaohui |
| Journal | Pesticide biochemistry and physiology |
| Year | 2017 |
| DOI |
10.1155/2017/4975714
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.