2d and 3d milled surface roughness of high volume fraction sicp/al composites
Clicks: 250
ID: 249149
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
250 views
25 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #20 of 54 articles by views in Journal of forensic and legal medicine
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper presents a study on surface roughness generated by high speed milling of high volume fraction (65%) silicon carbide particle-reinforced aluminum matrix (SiCp/Al) composites. Typical 2D (Ra and Rz) and 3D (Sa and Sq) surface roughness parameters were selected to evaluate the influence of the milling parameters on the surface quality in comparison with aluminum alloy. The 3D topography of the milled surface was studied as well. The results indicate that 3D parameters (Sa and Sq) are more capable to describe the influence of the milling parameters on the surface quality, and among them Sq is preferable due to its good sensitivity. Sq decreases with milling speed and increases with feed rate. The influence of axial depth of cut (ADOC) is negligible.
| Reference Key |
wang2015defence2d
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Tao Wang;Li-jing Xie;Xi-bin Wang;Teng-yi Shang |
| Journal | Journal of forensic and legal medicine |
| Year | 2015 |
| DOI |
10.1016/j.dt.2015.01.001
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.