pressure, feed rate, and abrasive mass flow rate influence on surface roughness for recombinant bamboo abrasive water jet cutting
Clicks: 230
ID: 247080
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
230 views
46 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #101 of 185 articles by views in medical archives (sarajevo, bosnia and herzegovina)
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 185 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The effects of pressure, feed rate, and abrasive mass flow rate on surface roughness were investigated during abrasive water cutting of recombinant bamboo. Two different thicknesses (10 mm and 15 mm) of recombinant bamboo were cut in the longitudinal and transversal directions by abrasive water jet. All experiments were arranged using response surface methodology. The parameter Ra was selected to represent the surface roughness. The value of Ra increased with an increase in feed rate and abrasive mass flow rate, but decreased with an increase in pressure. The surface roughness was lower when cutting the fiber longitudinally than when cutting transversally.
| Reference Key |
li2015bioresourcespressure,
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Rongrong Li;Mats Ekevad;Xiaolei Guo;Pingxiang Cao;Jie Wang;Qingqing Chen;Hong Xue |
| Journal | medical archives (sarajevo, bosnia and herzegovina) |
| Year | 2015 |
| DOI |
10.15376/biores.10.2.1998-2008
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.