conversion of engineering stresses to cauchy stresses in tensile and compression tests of thermoplastic polymers
Clicks: 282
ID: 246684
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
282 views
47 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #24 of 96 articles by views in materials science and engineering c
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Thermoplastic polymers exhibit non-isochoric behaviour during tensile and compression testing as well as particular deformations like local necking (tension) or buckling (compression). A method for the determination of Cauchy stresses from tensile and compression tests is presented, that considers the actual deformations of the test specimens. The exact geometry of the specimens in the respective present configuration is determined in photographs, which are taken continuously throughout the test. The engineering stresses at several time points are converted into Cauchy stresses using newly developed formulas in consideration of the actual specimen geometry. For validation finite element analyses of the tensile and compression tests are performed using the identified stress-strain curves. The numerical results show good agreement with the experiments for the tested polymers. Thus a method for conversion of engineering to Cauchy stresses in tensile and compression tests could be established considering the non-isochoric deformation in plasticity. With this method “true” stress-strain curves as input for finite element material models can be identified for arbitrary materials.
| Reference Key |
kerstin2016currentconversion
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Schümann Kerstin;Röhr Udo;Schmitz Klaus-Peter;Grabow Niels |
| Journal | materials science and engineering c |
| Year | 2016 |
| DOI |
10.1515/cdbme-2016-0142
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.