prototyping of cosmetic prosthesis of upper limb using additive manufacturing technologies
Clicks: 257
ID: 246495
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
257 views
40 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #36 of 71 articles by views in electrochemistry communications
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper describes prototyping of an individualized cosmetic arm prosthesis. Aim of the studies was to obtain an anatomically correct, lightweight prosthesis. It was accomplished using additive manufacturing technology of fused deposition modeling. The data was obtained by 3D scanning. An experimental concept of dual extrusion of two different materials was applied – the prosthesis was divided into an elastic shell and a rigid core, manufactured in one process. Obtained results were positive.
| Reference Key |
radosh2017advancesprototyping
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Aleksandra Radosh;Wiesław Kuczko;Radosław Wichniarek;Filip Górski |
| Journal | electrochemistry communications |
| Year | 2017 |
| DOI |
10.12913/22998624/70995
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.