influence of various process parameters on the density of sintered aluminium alloys

Clicks: 255
ID: 245409
2012
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #39 of 188 articles by views in the journal of nutrition

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 188 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
This paper presents the results of density measurements carried out on Alumix sintered parts. ECKA Alumix aluminium powders were used because of their wide application in the powder metallurgy industry. The compacts were produced using a wide range of compaction pressures for three different chemical compositions. The compacts were then sintered under a pure dry nitrogen atmosphere at three different temperatures. The heating and cooling rates were the same throughout the entire test. The results showed that the green density increases with compaction pressure, but that sintered density is independent of green density (compaction pressure) for each sintering temperature.
Reference Key
laska2012actainfluence Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Mateusz Laska;Jan Kazior
Journal the journal of nutrition
Year 2012
DOI
DOI not found
URL
https://ojs.cvut.cz/ojs/index.php/ap/article/view/1604
Keywords
powder metallurgy sintering civil engineering (general) densityengineering (general)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.