controlled morphology and mechanical characterisation of electrospun cellulose acetate fibre webs
Clicks: 110
ID: 241490
2013
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
110 views
13 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #66 of 80 articles by views in 19th international congress of chemical and process engineering, chisa 2010 and 7th european congress of chemical engineering, ecce-7
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The purpose was to interpret the varying morphology of electrospun cellulose acetate (CA) fibres produced from single and binary solvent systems based on solubility parameters to identify processing conditions for the production of defect-free CA fibrous webs by electrospinning. The Hildebrand solubility parameter () and the radius of the sphere in the Hansen space () of acetone, acetic acid, water, N,N-dimethylacetamide (DMAc), methanol, and chloroform were examined and discussed for the electrospinning of CA. The Hildebrand solubility parameter () of acetone and DMAc were found to be within an appropriate range for the dissolution of CA. The suitability of the binary solvent system of acetone: DMAc (2 : 1) for the continuous electrospinning of defect-free CA fibres was confirmed. Electrospun webs exhibited improved tensile strength and modulus after heat and alkali treatment (deacetylation) of the as-spun material, and no major fibre morphological degradation occurred during the deacetylation process.
| Reference Key |
ghorani2013internationalcontrolled
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;B. Ghorani;S. J. Russell;P. Goswami |
| Journal | 19th international congress of chemical and process engineering, chisa 2010 and 7th european congress of chemical engineering, ecce-7 |
| Year | 2013 |
| DOI |
10.1155/2013/256161
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.