experiments on optimal vibration control of a flexible beam containing piezoelectric sensors and actuators
Clicks: 161
ID: 239023
2003
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
161 views
15 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #98 of 275 articles by views in Nano letters
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 275 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
In this paper, a digital regulator is designed and experimentally implemented for a flexible beam type structure containing piezoelectric sensors and actuators by using optimal control design techniques. The controller consists of a linear quadratic regulator with a state estimator, namely a Kalman observer. The structure is a cantilever beam containing a set of sensor/actuator PVDF/PZT ceramic piezoelectric patches bonded to the beam surface at the optimal location obtained for the first three vibration modes. The equations of motion of the beam are developed by using the assumed modes technique for flexible structures in infinite-dimensional models. This paper uses a method of minimizing the effect of the removed higher order modes on the low frequency dynamics of the truncated model by adding a zero frequency term to the low order model of the system. A measure of the controllability and observability of the system based on the modal cost function for flexible structures containing piezoelectric elements (intelligent structures) is used. The observability and controllability measures are determined especially to guide the placement of sensors and actuators, respectively. The experimental and numerical transfer functions are adjusted by using an optimization procedure. Experimental results illustrate the optimal control design of a cantilever beam structure.
| Reference Key |
abreu2003shockexperiments
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Gustavo L.C.M. Abreu;José F. Ribeiro;Valder Steffen Jr |
| Journal | Nano letters |
| Year | 2003 |
| DOI |
10.1155/2003/594083
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.