factors affecting the consumption of energy during the milling of thermally modified and unmodified beech wood
Clicks: 175
ID: 236369
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
175 views
16 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #150 of 185 articles by views in medical archives (sarajevo, bosnia and herzegovina)
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 185 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper deals with an analysis of the energy efficiency of the milling of thermally modified and unmodified beech wood, taking into consideration the angular geometry of the cutting tool (milling cutter). The analysis was made using the METREL Power Q plus MI2392 device to measure the cutting power of the machine during milling with predetermined technical and technological cutter settings. The results were compared with respect to electricity savings in industrial production. The electrical power of the milling cutter, when machining thermally modified wood, was 5% less on average compared with the machining of unmodified wood under identical technological conditions.
| Reference Key |
kub2015bioresourcesfactors
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Jiří Kubš;Milan Gaff;Štefan Barcík |
| Journal | medical archives (sarajevo, bosnia and herzegovina) |
| Year | 2015 |
| DOI |
10.15376/biores.11.1.736-747
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.