an improved method for generating cutter points based on required form accuracy of the machining surface
Clicks: 117
ID: 236362
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
117 views
23 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #566 of 1,093 articles by views in journal of power sources
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 1,093 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Recently, freeform surfaces are widely used in optical field. Fabrication of freeform surface optics needs high machining accuracy and high efficiency simultaneously. Using the present ultraprecision manufacturing technologies, the form accuracy of freeform surfaces can reach submicrometric or even nanometer range but at the cost of low efficiency; moreover, the form accuracy cannot be predicted; the number and the position of cutter points cannot be accurately controlled before practical machining. A novel strategy of cutter points distribution is proposed in the paper, which is based on the required accuracy of the freeform surface and the machining efficiency can be improved by eliminating redundant cutter points on the processing trajectory. The new idea is detailed, simulations are conducted, and experiments are done to verify the feasibility of the proposed method in fabricating two sinusoidal ring surfaces.
| Reference Key |
ji2015mathematicalan
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Shijun Ji;Huijuan Yu;Ji Zhao |
| Journal | journal of power sources |
| Year | 2015 |
| DOI |
10.1155/2015/940643
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.