fire emission heights in the climate system – part 1: global plume height patterns simulated by echam6-ham2
Clicks: 88
ID: 233406
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
26.1
/100
88 views
8 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #699 of 850 articles by views in Journal of agricultural and food chemistry
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 850 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
We use the global circulation model ECHAM6 extended by the aerosol module
HAM2 to simulate global patterns in wildfire emission heights. Prescribed
plume heights in ECHAM6 are replaced by an implementation of a simple,
semi-empirical plume height parametrization. In a first step, the global
performance of the plume height parametrization is evaluated for plumes
reported in the Multiangle Imaging Spectroradiometer (MISR) Plume Height Project (MPHP) data set. Our results show that the
parametrization simulates a largely reasonable global distribution of plume
heights. While the modeled global mean plume height
(1411 ± 646 m) is in good agreement with the observed mean
(1382 ± 702 m), the upper and lower tails of the plume height
distribution tend to be slightly underrepresented. Furthermore, we compare
plume heights simulated by the simple parametrization to a more complex,
analytical plume model. Major differences in global plume height
distributions are found for the lowest 1.5 km, but reasonable
agreement is observed for higher plumes. In a second step, fire radiative power (FRP) as reported in the global fire assimilation system (GFAS) is used
to simulate plume heights for observed fires globally for the period
2005–2011. The global fraction of simulated daytime plumes injecting
emissions into the free troposphere (FT) ranges from 3.7 ± 0.7 to
5.2 ± 1.0 %. This range is comparable to results from
observational studies, but it is much lower than results for prescribed plume heights
in the ECHAM6-HAM2 standard setup. Nevertheless, occasionally deep emission
injections exceeding 5–7 km in height are simulated for intense
fires and favorable meteorological conditions. The application of
a prescribed diurnal cycle in FRP turns out to be of minor importance. For
a hypothetical doubling in FRP, moderate changes in plume heights of
100–400 m are simulated. These small changes indicate that
a potential future increase in fire intensity will only slightly impact the
emission heights on a global scale.
| Reference Key |
veira2015atmosphericfire
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;A. Veira;S. Kloster;S. Wilkenskjeld;S. Remy |
| Journal | Journal of agricultural and food chemistry |
| Year | 2015 |
| DOI |
10.5194/acp-15-7155-2015
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.