Transparent high-pressure nozzles for visualization of nozzle internal and external flow phenomena.

Clicks: 228
ID: 22740
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Star

Ranked #22 of 39 articles by views in The Review of scientific instruments

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
A new design for transparent high-pressure nozzles is presented in this work. This new design enables using the innovative Selective Laser Etching (SLE) method to manufacture transparent nozzles with outstanding accuracy. Therefore, not only the simultaneous visualization of the flow mechanics inside and outside the nozzle is enabled, but the manufacturing method applied also allows for the realization of individual nozzle geometries. Thus, nozzle internal flow phenomena (e.g., cavitation, swirl, and air inlet) and their influence on primary breakup can be analyzed with realistic nozzle geometries, e.g., for automotive applications. In addition, targeted three dimensional nozzle geometric parameters can be designed and manufactured in order to get specific tailor-made spray characteristics (e.g., droplet size distribution, spray angle, and penetration length). The basis for the transparent nozzle design is a two-parted nozzle, consisting of a re-machined original serial nozzle body and a transparent nozzle tip. The innovative SLE is used to produce the geometry of the transparent nozzle tip in fused silica, and laser polishing is utilized to achieve a maximum optical quality of nozzle surfaces for visualization. Bonding of both nozzle parts is achieved by a specially designed adhesive method. For a first feasibility study, a transparent nozzle with a simplified nozzle geometry is manufactured and used for a first study. In this study, simultaneous investigation of nozzle internal flow phenomena and their impact on spray breakup are visualized. First microscopic images of the nozzle internal flow show the formation of cavitation, its effect on nozzle internal temperature (apparent by differences in the fluid refractive index), and also the corresponding impact on spray breakup during injection. The penetration of ambient gas into the nozzle is verified at the end of injection as well as the influence of this air on the spray formation during the start of injection.
Reference Key
kirsch2019transparentthe Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Kirsch, Valeri;Hermans, Martin;Schönberger, Johannes;Ruoff, Ilona;Willmann, Michael;Reisgen, Uwe;Kneer, Reinhold;Reddemann, Manuel A;
Journal The Review of scientific instruments
Year 2019
DOI
10.1063/1.5065658
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.