spin coated (mx, zn1-x o), m= sn, al nanofibers investigation
Clicks: 6
ID: 222611
2013
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
1.5
/100
6 views
3 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #594 of 625 articles by views in utilitas mathematica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 625 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
(Mx, Zn 1-x O), M= Sn, Al nanofibers properties were investigated. Pure and M-doped zinc oxide films were fabricated onto a glass substrate by a facile and low cost spin coating route. X-rays analysis reveals that films crystallize with a wurtzite structure according to (002) orientation. The transmittance in the visible range was as high as 88 % at 550 nm. The doping increased slightly the transmittance, the as-grown films were high transparent in VIS and IR ranges. The optical band gap was a little bit changed by doping. AFM 3D-views revealed that grains were nanofibers with the size of 18.22, 18.23 and 44.27 nm respectively for pure, Al and Sn-doped ZnO films.
| Reference Key |
a.2013epjspin
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Tiburcio-Silver A.;Benouis C.E.;Benhaliliba M.;Ocak Y.S. |
| Journal | utilitas mathematica |
| Year | 2013 |
| DOI |
10.1051/epjconf/20134403003
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.