influence of volume working fluid and ambient temperature on cooling efficiency of loop thermosyphon
Clicks: 104
ID: 215727
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
104 views
9 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #363 of 625 articles by views in utilitas mathematica
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 625 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Article deal with research of device for electrical component cooling used to heat transfer working fluid phase change. Amount of heat flux transferred by thermosyphon loop depend from amount working fluid and from ambient temperature where is heat removal too. In article is described proposal construction of thermosyphon loop, comparisons of his cooling efficiency if is filled 40 % and 50 % volume of working fluid and condenser (ambient) temperature from 20, 30 up to 40 °C at heat load from 40 to 360 W.
| Reference Key |
p.2014epjinfluence
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Nemec P.;Malcho M.;Jandačka J.;Matušov J. |
| Journal | utilitas mathematica |
| Year | 2014 |
| DOI |
10.1051/epjconf/20146702080
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.