droplets deposition based on pulsated orifice ejection
Clicks: 170
ID: 211932
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
170 views
12 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #39 of 52 articles by views in adsorption science and technology
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
A novel equipment based on pulsated orifice ejection method was developed, which can be used to three-dimensional fabrication by depositing uniform micro-droplets one by one. The position accuracy of micro droplets in vertical deposition and the influence of velocity of working platform on lines deposition were carried out. The good reproducibility and accuracy of droplets deposition were proved by high speed camera and micro-structure observation. The results show that the overlapping with no obvious defects between adjacent droplets is obtained when the speed of working platform reaches around 600μm/s in lines deposition. Based on the above results, several thin wall components with good flatness were successfully obtained. Therefore this work provides a novel method for metal micro-droplets deposition manufacture.
| Reference Key |
wei2016journaldroplets
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;DONG Wei;WEI Yu-ting;KANG Shi-wei;GAI Ru-kun;XU Fu-min;LU Dong |
| Journal | adsorption science and technology |
| Year | 2016 |
| DOI |
10.11868/j.issn.1001-4381.2016.10.001
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.