Ablation Behavior of the SiC-Coated Three-Dimensional Highly Thermal Conductive Mesophase-Pitch-Based Carbon-Fiber-Reinforced Carbon Matrix Composite under Plasma Flame.
Clicks: 337
ID: 21185
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
64.9
/100
337 views
217 readers
Trending
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #140 of 812 articles by views in Materials (Basel, Switzerland)
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 812 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This study is focused on a novel high-thermal-conductive C/C composite used in heat-redistribution thermal protection systems. The 3D mesophase pitch-based carbon fiber (CF) preform was prepared using CF in the X (Y) direction and polyacrylonitrile carbon fiber (CF) in the Z direction. After the preform was densified by chemical vapor infiltration (CVI) and polymer infiltration and pyrolysis (PIP), the 3D high-thermal-conductive C/C (C/C) composite was obtained. The prepared C/C composite has higher thermal conduction in the X and Y directions. After an ablation test, the CF becomes needle-shaped, while the CF shows a wedge shape. The fiber/matrix and matrix/matrix interfaces are preferentially oxidized and damaged during ablation. After being coated by SiC coating, the thermal conductivity plays a significant role in decreasing the hot-side temperature and protecting the SiC coating from erosion by flame. The SiC-coated C/C composite has better ablation resistance than the SiC-coated C/C composite. The mass ablation rate of the sample is 0.19 mg·(cm·s), and the linear ablation rate is 0.52 μm·s.
| Reference Key |
ye2019ablationmaterials
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Ye, Chong;Huang, Dong;Li, Baoliu;Yang, Pingjun;Liu, Jinshui;Wu, Huang;Yang, Jianxiao;Li, Xuanke; |
| Journal | Materials (Basel, Switzerland) |
| Year | 2019 |
| DOI |
E2723
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.