comparative study of frequency converters for doubly fed induction machines
Clicks: 102
ID: 208926
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
102 views
3 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #864 of 935 articles by views in journal of physics: conference series
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 935 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The efficient utilization of energy sources seems to be one of the most challenging problems for designers and scientists alike. This challenge particularly applies to power electronics, where the increasing value of energy density leads to demands for optimization processes and better exploitation (and distribution) of available power sources. As a result, the implementation of frequency-controlled systems is more often in the spotlight. The systems with doubly fed induction machines and a frequency converter in the rotor circuit are typical representatives of these demands. In a wide spectrum of power electronic systems, frequency converters are often used that have a constant current, a diode rectifier, and a thyristor inverter. This article provides a novel approach to modeling methodology, and presents a unique comparison of four different frequency converter schemes that are connected to a doubly fed induction machine. This article presents the modeling methodology itself, as well as the results based on an asynchronous generator motor fed by different frequency converters, a spectral analysis of the output voltage of the used frequency converters, and a comparison of the different technologies. Based on the above, this paper recommends the use of a multistage-multilevel frequency converter scheme.
| Reference Key |
nahdi2018sustainabilitycomparative
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Tarek Nahdi;Dusan Maga |
| Journal | journal of physics: conference series |
| Year | 2018 |
| DOI |
10.3390/su10030594
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.