Measurement of Dynamic Responses from Large Structural Tests by Analyzing Non-Synchronized Videos.

Clicks: 170
ID: 20863
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #1,449 of 1,694 articles by views in sensors

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 1,694 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Image analysis techniques have been employed to measure displacements, deformation, crack propagation, and structural health monitoring. With the rapid development and wide application of digital imaging technology, consumer digital cameras are commonly used for making such measurements because of their satisfactory imaging resolution, video recording capability, and relatively low cost. However, three-dimensional dynamic response monitoring and measurement on large-scale structures pose challenges of camera calibration and synchronization to image analysis. Without satisfactory camera position and orientation obtained from calibration and well-synchronized imaging, significant errors would occur in the dynamic responses during image analysis and stereo triangulation. This paper introduces two camera calibration approaches that are suitable for large-scale structural experiments, as well as a synchronization method to estimate the time difference between two cameras and further minimize the error of stereo triangulation. Two structural experiments are used to verify the calibration approaches and the synchronization method to acquire dynamic responses. The results demonstrate the performance and accuracy improvement by using the proposed methods.
Reference Key
yang2019measurementsensors Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Yang, Yuan-Sen;
Journal sensors
Year 2019
DOI
E3520
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.