reactions of al-ptfe under impact and quasi-static compression
Clicks: 93
ID: 205019
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
27.6
/100
93 views
19 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #212 of 254 articles by views in bulletin of the korean chemical society
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 254 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Conventionally, the Al-PTFE is thought to be inert under quasi-static or static loads. However, here we reported an initiation phenomenon of Al-PTFE under quasi-static compression. Quasi-static tests suggest that reacted Al-PTFE samples had much higher toughness than unreacted samples. Dynamic test showed that the energy level needed to initiate the material was similar for quasi-static compression (88–100 J) and dynamic impact (77–91 J). The difference in density indicates that unreacted Al-PTFE has a higher crystallinity, which leads to the lower toughness. SEM images show numerous PTFE fibrils in unreacted composites which made the sample harder to crack and initiate.
| Reference Key |
feng2015advancesreactions
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Bin Feng;Xiang Fang;Yu-chun Li;Shuang-zhang Wu;Yi-ming Mao;Huai-xi Wang |
| Journal | bulletin of the korean chemical society |
| Year | 2015 |
| DOI |
10.1155/2015/582320
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.