a comparative evaluation of fluidized bed assisted drag finishing and centrifugal disk dry finishing
Clicks: 189
ID: 204032
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
189 views
20 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #354 of 430 articles by views in International journal of molecular sciences
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 430 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Drag finishing of brass (Cu-30 wt.% Zn) rings using fluidized abrasives, which is a new finishing technology, is comparatively evaluated with centrifugal disk finishing. The comparison was performed by selecting the same abrasive granulates of two different sizes and operating the equipment for the same processing time or at their respective maximum speeds. The experimental analysis investigated the change in workpiece morphology, material removal during finishing and dimensional accuracy. The results showed that each of the types of equipment investigated in the study were capable of a high finishing performance with a relatively short processing time. However, fluidized bed assisted drag finishing was more effective than centrifugal disk finishing in both the achievable quality of the processed parts and reduced processing time. In contrast, centrifugal disk finishing was preferable whenever low erosion and stringent dimensional tolerances were demanded.
| Reference Key |
barletta2014engineeringa
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;M. Barletta;A. Gisario;S. Venettacci;G. Rubino |
| Journal | International journal of molecular sciences |
| Year | 2014 |
| DOI |
10.1016/j.jestch.2014.03.007
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.