mechanical properties of filled high density polyethylene

Clicks: 45
ID: 202072
2015
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #74 of 77 articles by views in zaporožskij medicinskij Žurnal

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Mechanical properties of (HDPE M624) with three filler (inorganic and organic) composites were assessed with respect to the effect of the filler content. The filler varied from (5% to 25%) by weight in the composite. Obvious improvement in the mechanical parameters was recorded depending on the filler type and mesh size. The mechanical properties of loaded compressed sample have been evaluated through several parameters concerning the elastic deformation based on measuring the load–elongation characteristics. The behavior of stress–strain curve was analyzed in terms of cold drawing model. No experimental difficulties appeared at any mixing ratio, and these difficulties were due to the separation in phase which makes the sample possible for processing in the normal extruders.
Reference Key
khalaf2015journalmechanical Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Moayad N. Khalaf
Journal zaporožskij medicinskij Žurnal
Year 2015
DOI
10.1016/j.jscs.2011.12.024
URL
http://www.sciencedirect.com/science/article/pii/S1319610311002729
Keywords
mechanical properties polyethylene (pe)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.