numerical simulation and experiment for underwater shock wave in newly designed pressure vessel
Clicks: 147
ID: 201750
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
147 views
22 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #20 of 39 articles by views in contrast media & molecular imaging
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Modern eating habits depend in large part on the development of food processing technology. Thermal treatments are often performed in the conventional food processing, but it can cause discoloration and loss of nutrients of the food by thermal processing or treatment. On the other hand, food processing using an underwater shock wave has little influence of heat and its processing time is very short, preventing the loss of nutrients. In this research optical observation experiment and the numerical simulation were performed, in order to understand and control the behavior of the underwater shock wave in the development of the processing container using an underwater shock wave for the factory and home. In this experiment a rectangular container was used to observe the behavior of the underwater shock wave. In the experiment, the shock wave was generated by using explosive on the shock wave generation side. The shock wave, which passed through the phosphor bronze and propagated from the aluminum sidewall, was observed on the processing container side. Numerical simulation of an analogous experimental model was investigated, where LS-DYNA software was used for the numerical simulation. The comparative study of the experiment and the numerical simulation was investigated. The behavior of a precursor shock wave from the device wall was able to be clarified. This result is used for development of the device in numerical simulation.
| Reference Key |
shibuta2016internationalnumerical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;M Shibuta;H Hamashima;S Itoh |
| Journal | contrast media & molecular imaging |
| Year | 2016 |
| DOI |
10.1260/1750-9548.4.3.241
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.