numerical simulation analysis of unfilled and filled reinforced polypropylene on thin-walled parts formed using the injection-moulding process
Clicks: 152
ID: 194980
2015
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
152 views
25 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #41 of 80 articles by views in 19th international congress of chemical and process engineering, chisa 2010 and 7th european congress of chemical engineering, ecce-7
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Thin-walled moulding technology has attracted increasing attention, particularly in electronic packing applications. The injection moulding of shallow, thin-walled parts with a thickness of 0.7 mm was performed using three types of materials from polypropylene, PP (PP, PP + 50 wt% wood composite, and PP + 10 wt% glass fibre composite). The highest deflection resulting from PP + 50 wt% wood does not occur in the critical area of the thin-walled part compared with PP + 10 wt% glass fibre. In addition, the results revealed that the warpage at the midpoint of the part surface injected using PP + 50 wt% wood is 0.04 mm lower than the value of 0.08 mm obtained when injected using PP + 10 wt% glass fibre. The warpage was hypothesised to result from the residual stress caused by nonuniform volumetric shrinkages formed during the solidification phase.
| Reference Key |
azaman2015internationalnumerical
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;M. D. Azaman;S. M. Sapuan;S. Sulaiman;E. S. Zainudin;A. Khalina |
| Journal | 19th international congress of chemical and process engineering, chisa 2010 and 7th european congress of chemical engineering, ecce-7 |
| Year | 2015 |
| DOI |
10.1155/2015/659321
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.