influence of water saturation on the mechanical behaviour of low-permeability reservoir rocks

Clicks: 163
ID: 194608
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #357 of 526 articles by views in acs combinatorial science

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 526 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
The influence of water on the mechanical properties of rocks has been observed by many researchers in rock engineering and laboratory tests, especially for sedimentary rocks. In order to investigate the effect of water saturation on the mechanical properties of low-permeability rocks, uniaxial compression tests were conducted on siltstone with different water contents. The effects of water on the strength, elastic moduli, crack initiation and damage thresholds were observed for different water saturation levels. It was found that 10% water saturation level caused more than half of the reductions in mechanical properties. A new approach is proposed to analyze the stress-strain relations at different stages of compression by dividing the axial and lateral stress-strain curves into five equal stress zones, where stress zones 1–5 refer to 0%–20%, 20%–40%, 40%–60%, 60%–80% and 80%–100% of the peak stress, respectively. Stress zone 2 represents the elastic range better than stress zone 3 which is at half of the peak stress. The normalized crack initiation and crack damage stress thresholds obtained from the stress-strain curves and acoustic emission activities averaged 31.5% and 83% of the peak strength respectively. Pore pressure is inferred to take part in the deformation of low-permeability siltstone samples, especially at full saturation levels. A change of failure pattern from multi-fracturing to single shear failure with the increase of water saturation level was also observed.
Reference Key
zhang2017energiesinfluence Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Decheng Zhang;Ranjith Pathegama Gamage;Mandadige Samintha Anne Perera;Chengpeng Zhang;Wanniarachchillage Ayal Maneth Wanniarachchi
Journal acs combinatorial science
Year 2017
DOI
10.3390/en10020236
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.