study of interface charge densities for zro2 and hfo2 based metal-oxide-semiconductor devices

Clicks: 141
ID: 192405
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #174 of 254 articles by views in bulletin of the korean chemical society

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 254 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
A thickness-dependent interfacial distribution of oxide charges for thin metal oxide semiconductor (MOS) structures using high-k materials ZrO2 and HfO2 has been methodically investigated. The interface charge densities are analyzed using capacitance-voltage (C-V) method and also conductance (G-V) method. It indicates that, by reducing the effective oxide thickness (EOT), the interface charge densities (Dit) increases linearly. For the same EOT, Dit has been found for the materials to be of the order of 1012 cm−2 eV−1 and it is originated to be in good agreement with published fabrication results at p-type doping level of 1×1017 cm−3. Numerical calculations and solutions are performed by MATLAB and device simulation is done by ATLAS.
Reference Key
maity2014advancesstudy Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;N. P. Maity;Reshmi Maity;R. K. Thapa;S. Baishya
Journal bulletin of the korean chemical society
Year 2014
DOI
10.1155/2014/497274
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.