effects of high egr rate on dimethyl ether (dme) combustion and pollutant emission characteristics in a direct injection diesel engine
Clicks: 200
ID: 186366
2013
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
200 views
18 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #282 of 526 articles by views in acs combinatorial science
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 526 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This study investigated the effects of high exhaust gas recirculation (EGR) rates on dimethyl ether (DME) fuel combustion performance, exhaust emissions and particle emission characteristics in a small direct injection diesel engine under various injection timings. To examine the effect of EGR and injection timings, the experiment was performed under high EGR rates (0%, 30%, 50%) and injection timings were varied from 40° before top dead center (BTDC) to top dead center (TDC) of the crank angle to examine the effects of early injection of DME fuel. The combustion pressures and heat release rates for different EGR rates followed similar trends. As the injection timing was advanced, the indicated mean effective pressure (IMEP) differed little in response to EGR rate in the range from TDC to 25° BTDC, and more for crank angles beyond 25° BTDC. DME combustion exhibited very little soot emission, but soot emission increased slightly with EGR rate. The use of high EGR during combustion produced very low NOx concentrations but increased HC and CO emissions for advanced injection timings from 25° BTDC to 40° BTDC. The use of EGR increased both the emissions of total particle number and particle volume over the whole range of the injection timings; for all cases, total particle volume decreased as injection timing was advanced.
| Reference Key |
lee2013energieseffects
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Chang Sik Lee;Seung Chul Han;Seung Hyun Yoon |
| Journal | acs combinatorial science |
| Year | 2013 |
| DOI |
10.3390/en6105157
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.