Multicatalysis Combining 3D-Printed Devices and Magnetic Nanoparticles in One-Pot Reactions: Steps Forward in Compartmentation and Recyclability of Catalysts.

Clicks: 418
ID: 1859
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #18 of 899 articles by views in ACS applied materials & interfaces

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 899 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
A tricatalytic compartmentalized system that immobilizes metallic species to perform one-pot sequential functionalization is described: a three-dimensional (3D)-printed palladium monolith, ferritic copper(I) magnetic nanoparticles, and a 3D-printed polypropylene capsule-containing copper(II) loaded onto polystyrene-supported 1,5,7-triazabicyclo[4.4.0]dec-5-ene (PS-TBD) allowed the rapid synthesis of diverse substituted 1-([1,1'-biphenyl]-4-yl)-1 H-1,2,3-triazoles. The procedure is based on the Chan-Lam azidation/copper alkyne-azide cycloaddition/Suzuki reaction strategy in the solution phase. This catalytic system enabled the efficient assembly of the final compounds in high yields without the need for special additives or intermediate isolation. The monolithic catalyst-containing immobilized palladium species was synthesized by surface chemical modification of a 3D-printed silica monolith using a soluble polyimide resin as a key reagent, thus creating an extremely robust composite. All three immobilized catalysts described here were easily recovered and reused in numerous cycles. This work exemplifies the role of 3D printing in the design and manufacture of devices for compartmented multicatalytic systems to carry out complex one-pot transformations.
Reference Key
sanchez-dazmarta2019multicatalysisacs Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Sanchez Díaz-Marta, Antonio;Yáñez, Susana;Tubío, Carmen R;Barrio, V Laura;Piñeiro, Yolanda;Pedrido, Rosa;Rivas, José;Amorín, Manuel;Guitián, Francisco;Coelho, Alberto;
Journal ACS applied materials & interfaces
Year 2019
DOI
10.1021/acsami.9b08119
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.