microstructures and mechanical properties of al-7sn-1.1ni-cu-0.2ti bearing alloy

Clicks: 255
ID: 178744
2017
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #25 of 52 articles by views in adsorption science and technology

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
The microstructures and mechanical properties of Al-7Sn-1.1Ni-Cu-0.2Ti alloy were studied by using SEM, EDS, OM and WDW-100KN universal tensile testing machine, the lubricating properties were completed by the disk-pin testing machine. The results show that the solidification shrinkage of alloy is 1.13%; the tensile strength, yield strength, elongation and Brinell hardness in the as-cast state are 191, 147MPa, 15.6% and 34.6HBS, with the executing of low temperature aging and annealing process, the tensile strength increases slightly and the yield strength has no significant changes; the elongation and Brinell hardness exhibit the tendency of increasing firstly and then decreasing. Morphology of eutectic Sn phase that distributes nearby the grain boundary transforms from plate-like shape and bone-shape to lamellar and short rod gradually under the function of the interfacial tension. Due to some eutectic phase melts by absorbing energy from heat treatment process, cavity structure forms around grain boundaries, the average grain size of primary α-Al substrate is 182μm. Comparing with the as-cast and annealing at 340℃ for 6h states, the friction coefficient decreases by 28.6% and 78.6%, together with the wear volume reduces by 157.1% and 471.4% after aging at 175℃ for 10h, the fracture morphology shows mainly intergranular fracture and dimple fracture.
Reference Key
zhen-zhong2017journalmicrostructures Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;FAN Zhen-zhong;XIONG Yan-cai;LU Zheng;SUN Gang;WANG Sheng-qiang
Journal adsorption science and technology
Year 2017
DOI
10.11868/j.issn.1001-4381.2016.001029
URL
http://jme.biam.ac.cn/CN/Y2017/V45/I6/8
Keywords
microstructure mechanical property mechanics of materials

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.