microstructure and mechanical properties of mechanically alloyed ods copper alloy for fusion material application
Clicks: 210
ID: 177024
2018
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
210 views
45 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #21 of 25 articles by views in american business law journal
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Advanced oxide dispersion strengthened copper alloys are promising structural materials for application in divertor system of future fusion reactors due to high irradiation resistance, high thermal conductivity, and good mechanical properties. In this study, a new ODS copper including 0.42wt%Y2O3 nanosized oxide particles was developed successfully by mechanical alloying method using addition of 1 wt% Stearic acid in Ar atmosphere. Mechanical alloying resulted in decrease of crystallite size to 28 nm in concurrent with increment of dislocation density and hardness to the saturated level of 1.7×1015m−2 and 226HV0.1 after 48 h milling, respectively. Consolidated ODS copper by SPS and then hot roll-annealing at 900 °C/60 min showed an average grain size of 1.1 µm with a near random texture. Furthermore, TEM observations demonstrated fine semicoherent Y2O3 oxide particles distributed with a misfit parameter (δ) of 0.17 in copper matrix with an average size of 10.8 nm and interparticle spacing of 152 nm. Finally, tensile test evaluation determined comparable mechanical properties of the annealed ODS copper (Cu-0.42wt%Y2O3) with Glidcop-Al25 including a yield strength of 272 MPa and total elongation of 12%, by two mechanisms of grain boundary strengthening and oxide particle strengthening. Keywords: ODS copper, Mechanical alloying, Microstructure, Mechanical properties
| Reference Key |
aghamiri2018nuclearmicrostructure
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;S.M.S. Aghamiri;N. Oono;S. Ukai;R. Kasada;H. Noto;Y. Hishinuma;T. Muroga |
| Journal | american business law journal |
| Year | 2018 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.