the influence of speed and press factor on oriented strand board performance in continuous press
Clicks: 204
ID: 176018
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
204 views
22 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #127 of 185 articles by views in medical archives (sarajevo, bosnia and herzegovina)
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 185 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Three-layer cross-oriented strand boards, OSB type 3 of 10 mm thick, were industrially manufactured from a mixture of wood species including 50% softwoods, 25% beech, and 25% low hardwoods, using a continuous press line. The effects of line speed and press factor on physical and mechanical properties of OSB/3 (exterior grade) were evaluated, keeping nearly constant the face-core adhesive ratio. The manufactured boards were classified into five groups depending on the pressing parameters. The experimental results showed that all mechanical properties increased, with increasing press factor and decreasing line speed. The ratios of bending strength (MOR) and the modulus of elasticity (MOE) parallel to perpendicular were 1.73 to 1.89 and 2.18 to 2.24, respectively. No significant differences in thickness swell and water absorption were observed. The lowest density was achieved at higher speed, although there was no large variation in densities between groups. Thickness swelling and internal bond after boil test exceeded the EN 300 standard requirements for OSB/3 moisture resistance, excepting a few boards. The results revealed that a correlation between speed and press factor is necessary in order to improve mechanical properties and to keep the physical performance of boards within a limited range of values.
| Reference Key |
ciobanu2014bioresourcesthe
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Valentina D. Ciobanu;Octavia Zeleniuc;Adela-Eliza Dumitrascu;Badea Lepadatescu;Bogdan Iancu |
| Journal | medical archives (sarajevo, bosnia and herzegovina) |
| Year | 2014 |
| DOI |
10.15376/biores.9.4.6805-6816
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.