wear-dependent specific coefficients in a mechanistic model for turning of nickel-based superalloy with ceramic tools

Clicks: 434
ID: 167407
2017
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #1 of 7 articles by views in orbit journal

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Difficult to cut materials such as nickel and titanium alloys are used in the aeronautical industry, the former alloys due to its heat-resistant behavior and the latter for the low weight - high strength ratio. Ceramic tools made out alumina with reinforce SiC whiskers are a choice in turning for roughing and semifinishing workpiece stages. Wear rate is high in the machining of these alloys, and consequently cutting forces tends to increase along one operation.
Reference Key
norberto2017openwear-dependent Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;López de Lacalle Luis Norberto;Urbicain Pelayo Gorka;Fernández-Valdivielso Asier;Alvarez Alvaro;González Haizea
Journal orbit journal
Year 2017
DOI
10.1515/eng-2017-0024
URL
http://www.degruyter.com/view/j/eng.2017.7.issue-1/eng-2017-0024/eng-2017-0024.xml?format=INT
Keywords
ceramics civil engineering (general) time-dependent wearengineering (general)

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.