application of numerical simulations for a tentative seismic microzonation of the city of rome

Clicks: 202
ID: 163029
1995
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #76 of 205 articles by views in desalination

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 205 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Abstract
A hybrid technique, based on mode summation and finite differences, was used to silnulate the ground motion induced in the city of Rome by possible earthquakes occurring in the main seisrnogenetic areas surrounding the city: the Central Apennines and the Alban Hills. The results of the numerical simulations are used for a seismic inicrozonation in the city of Rome, which can be used for the retrofitting of buildings of special social and cultural value. On the basis of our analysis Rome can be divided into six main zones: (1) the edges and (2) the central part of the alluvial basin of the River Tiber; (3) the edges and (4) the central part of the Paleotiber basin; the areas outside the large basins of the Tiber and Paleotiber, where we distinguish between (5) areas without, and (6) areas with a layer of volcanic rocks close to the surface. The strongest amplification effects have to be expected at the edges of the Tiber basin, with maximum spectral amplification of the order of 5 to 6, and strong arnplifications occur inside the entire alluvial basin of the Tiber. The presence of a near-surface layer of rigid material is not sufficient to classify a location as a <<hard-rock site>> when the rigid material covers a sedimentary complex. The reason is that the underlying sedimentary complex causes amplifications at the surface due to resonance effects. This phenomenon can be observed in the Paleotiber basin, where spectral amplifications in the frequency range 0.4-1.0 Hz reach values of the order of 3 to 4.
Reference Key
panza1995annalsapplication Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;G. F. Panza;P. Suhadolc;C. Iodice;D. Fah
Journal desalination
Year 1995
DOI
10.4401/ag-4079
URL
Keywords

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

No comments yet. Be the first to comment on this article.