influence of impurities on the luminescence of er3+ doped batio3 nanophosphors
Clicks: 154
ID: 157364
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
154 views
11 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #256 of 443 articles by views in reproductive biology and endocrinology
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 443 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The influence of the presence of barium carbonate (BaCO3) phase on the luminescence properties of barium titanate nanocrystals (BaTiO3) powders was investigated. Structural and optical characterizations of erbium (Er3+) doped BaTiO3 synthesized by the sol-emulsion-gel were performed. Using Fourier transform infrared spectroscopy and X-ray powder diffraction, we identified the presence of impurities related to BaCO3 and quantified its fraction. It was observed that the presence of BaCO3 phase, even at low levels, depletes significantly the infrared-to-visible upconverted luminescence efficiency of the produced nanopowders.
| Reference Key |
webler2014journalinfluence
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;G. D. Webler;M. J. M. Zapata;G. S. Maciel;A. Patra;J. M. Hickmann;M. A. R. C. Alencar |
| Journal | reproductive biology and endocrinology |
| Year | 2014 |
| DOI |
10.1155/2014/708719
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.