the influence of velocity overshoot movement artifact on isokinetic knee extension tests
Clicks: 196
ID: 156201
2010
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
196 views
35 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #64 of 92 articles by views in journal of the turkish chemical society section a: chemistry
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Exercise on an isokinetic device involves three distinct movement phases: acceleration, constant velocity, and deceleration. Inherent in these phases are unique occurrences that may confound test data and, thereby, test interpretation. Standard methods of data reduction like windowing and other techniques consist of removing the acceleration and deceleration phases in order to assure analysis under constant velocity conditions. However, none of these techniques adequately quantify the velocity overshoot (VO) movement artifact which is a result of the devices resistance imposed to the limb. This study tested the influence of VO on isokinetic data interpretation. A computational algorithm was developed to accurately identify each movement phase and to delineate the VO segment. Therefore, the VO was then treated as a fourth and independent phase. A total of sixteen healthy men (26.8 ± 4.7 yrs, 1.76 ± 0.05 m, and 79.2 ± 9.4 kg) performed two sets of ten maximal concentric extension repetitions of their dominant knee (at 60º·s-1 and 180º·s-1), on separate days and in a counterbalanced order, on a Biodex System 3 Pro dynamometer. All the phases of the isokinetic exercise were measured in terms of their biomechanical descriptors and according to the developed algorithm, the windowing method, and a data reduction technique that eliminates the first and last 10º of the total range of motion. Results showed significant differences (p < 0.05) between the constant velocity phases found by each method: the largest segment was obtained with the windowing method; the second one, with the algorithm; and the smallest, with data reduction technique. The point of peak torque was not affected by none of the techniques, but significant differences (p < 0.05) were found between the data including and not including the VO phase, concerning total work, time interval, and average length of load range: VO represents more than 10% of the amount calculated in constant velocity phase. As a consequence, the correct removal of VO was suggested as a required procedure to adequately interpret isokinetic tests. Therefore, the use of the proposed algorithm is advisable in order to perform analysis according to the isokinetic definition
| Reference Key |
schwartz2010journalthe
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Fabiano Peruzzo Schwartz;Martim Bottaro;Rodrigo Souza Celes;Lee E. Brown;Francisco Assis de Oliveira Nascimento |
| Journal | journal of the turkish chemical society section a: chemistry |
| Year | 2010 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.