fem simulation of the tube rolling process in diescher’s mill
Clicks: 205
ID: 151963
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
205 views
32 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #58 of 71 articles by views in electrochemistry communications
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper deals with the issue of numerical modelling of the piercing process of a thick–walled bush in a two-rolled skew rolling mill, equipped with guiding devices of Diescher’s type. After a short characteristic of the subject matter, the developed geometric model of the process was discussed, with taking kinematics of tools movement and thermal phenomena present in metal during forming into consideration. Next, the results of calculations were presented in a form of fields of strain, damage criterion and temperature. Distributions of force parameters acting on particular tools during the process of bush rolling were also given.
| Reference Key |
pater2014advancesfem
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Zbigniew Pater;Arkadiusz Tofil |
| Journal | electrochemistry communications |
| Year | 2014 |
| DOI |
10.12913/22998624.1105165
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.