microstructure and properties of m g-li-a lalloys with mn addition
Clicks: 116
ID: 141865
2006
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
116 views
9 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #34 of 41 articles by views in bioconjugate chemistry
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
Mg-xLi-Al alloys with Mn addition from 0.2% to 1.5% by wt. were produced and studied. The density of the alloys is very low , betw een 1.21 g/cm3 and 1.64 g/cm3, while the microstructures change from single α-,(α＋β)-,to single β-phase with lithium contentrising from 5% to 22% by wt.The m ain alloy studied w as LA 92 alloy with Mn addition. The results ofthe tensile tests show that the strength decreases with increasing lithium content, while the elongation increases sharply,and the U TS and Y S rise by 26.8% and 22.7% respectively,when 0.5% by wt. Mn is added.It is also known,by microstructure observation,SEM with EDS and X-ray analysis,that adding Mn can produce som e new hard phases in the alloy, which may worsen the tensile properties.
| Reference Key |
hong-bin2006chinamicrostructure
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Li Hong-bin;Yang Guang-chun;Liang Chun-lin |
| Journal | bioconjugate chemistry |
| Year | 2006 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.