investigation of surface integrity, material removal rate and wire wear ratio for wedm of nimonic 80a alloy using gra and taguchi method
Clicks: 244
ID: 141363
2014
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
244 views
33 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #275 of 430 articles by views in International journal of molecular sciences
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 430 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper presents the investigation on surface integrity, material removal rate and wire wear ratio of Nimonic 80A using WEDM process. Taguchi's design of experiments methodology has been used for planning and designing the experiments. All of the input parameters and two factors interactions have been found to be statically significant for their effects on the response of interest. SEM was performed on the machined samples to investigate the effect and microstructure of the samples after machining. A higher pulse-on time setting leads to thicker recast layer. At lower value of pulse-on time and higher value of pulse-off time, the wire deposition on the machined surface is low.
| Reference Key |
goswami2014engineeringinvestigation
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Amitesh Goswami;Jatinder Kumar |
| Journal | International journal of molecular sciences |
| Year | 2014 |
| DOI |
10.1016/j.jestch.2014.05.002
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.