Arduino Based Automatic Irrigation System
Clicks: 301
ID: 13904
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
64.8
/100
301 views
189 readers
Trending
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #19 of 46 articles by views in adbu journal of electrical and electronics engineering (ajeee)
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
In the present days, the farmers are suffering from severe drought like condition throughout the year. The main objective of this paper is to provide a system leads to automatic irrigation thereby saving time, money & power of the farmers, gardeners in greenhouses etc. Manual intervention is common in traditional farm-land irrigation techniques. This paper presents a technique for Arduino based Automatic Irrigation System. With this automated technology of irrigation, human intervention can be minimized. The moisture sensors will be bedded in on the field. Whenever there is a change in water concentration, these sensors will sense the change and gives an interrupt signal to the microcontroller. Soil is one of the most fragile resources whose soil pH property used to describe the degree of the acidity or basicity, which affects nutrient availability and ultimately plant growth. Thus, the system will provide automation, remote controlling and increased efficiency. The humidity sensor is connected to internal ports of microcontroller via comparator; whenever there is a fluctuation in temperature and humidity of the environment, these sensors sense the change in temperature and humidity and give an interrupt signal to the micro-controller and thus the motor is activated. A buzzer is used to indicate that the pump is on.
| Reference Key |
minz2019arduinoadbu
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Sandeep Minz;Ankit Saha;Mrinmoy Ranjan Dev; |
| Journal | adbu journal of electrical and electronics engineering (ajeee) |
| Year | 2019 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.