microstructure and mechanical properties of ni3al intermetallics prepared by directional solidification electromagnetic cold crucible technique
Clicks: 190
ID: 136098
2017
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
190 views
33 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #21 of 41 articles by views in bioconjugate chemistry
Most read
Least read
Bar heights use a square-root scale.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The present work focused on the Ni3Al-based alloy with a high melting point. The aim of the research is to study the effect of withdrawal rate on the microstructures and mechanical properties of directionally solidified Ni-25Al alloy. Ni3Al intermetallics were prepared at different withdrawal rates by directional solidification (DS) in an electromagnetic cold crucible directional solidification furnace. The DS samples contain Ni3Al and NiAl phases. The primary dendritic spacing (λ) decreases with the increasing of withdrawal rate (V), and the volume fraction of NiAl phase increases as the withdrawal rate increases. Results of tensile tests show that ductility of DS samples is enhanced with a decrease in the withdrawal rate.
| Reference Key |
ding2017chinamicrostructure
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Hong-sheng Ding;Guo-tian Wang;Rui-run Chen |
| Journal | bioconjugate chemistry |
| Year | 2017 |
| DOI |
10.1007/s41230-017-6111-5
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.