tribological analysis of mg2si particulates reinforced powder metallurgy magnesium alloy composites under oil lubrication condition

Clicks: 340
ID: 135112
2009
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Star

Ranked #5 of 254 articles by views in bulletin of the korean chemical society

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 254 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
For the evaluation of wear behavior of Mg composites under oil lubrication conditions, powder metallurgy Mg97Y2Zn1 alloy reinforced with additive Mg2Si particles were fabricated by the repeated plastic working (RPW) and hot extrusion. The RPW process was effective in refining both Mg2Si reinforcements and α-Mg grains causing the matrix hardening. When increasing the repetition number of RPW process from 200 to 600 cycles, the particle size of Mg2Si additives changed from 8 μm to 1~2 μm, and α-Mg grain size was 1 μm or less. With regard to the defensive and offensive properties of Mg alloys reinforced with Mg2Si dispersoids, the composite had superior adhesive wear resistance compared with the conventional Mg alloys because of its extremely high microhardness of 95~180 Hv by RPW process. The uniform distribution of refined Mg2Si particles was useful for improving both defensive and offensive properties against AZ31B counter disk specimens. The Mg2Si prominent dispersoids in the matrix were also effective in forming the oil grooves around them, and caused the low and stable friction coefficient. On the other hand, in the case of the composite containing coarse Mg2Si particles, severely deep scratches were given on the counter face of the AZ31B disk, and resulted in an unstable and high friction coefficient.
Reference Key
kondoh2009advancestribological Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors ;Katsuyoshi Kondoh;Junko Umeda;Kenshi Kawabata
Journal bulletin of the korean chemical society
Year 2009
DOI
10.1155/2009/628737
URL
http://dx.doi.org/10.1155/2009/628737
Keywords
materials of engineering and construction mechanics of materials

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.