the effect of spiral grain on energy requirement of plane milling of scots pine (pinus sylvestris l.) wood
Clicks: 185
ID: 132585
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Emerging Content
30.0
/100
185 views
12 readers
AI Quality Assessment
Not analyzed
Readership in this journal
EmergingRanked #132 of 185 articles by views in medical archives (sarajevo, bosnia and herzegovina)
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 185 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The effect of spiral grain angle on the cutting power was tested during plane milling of Scots pine wood. It is known that cutting resistance depends on the arrangement of grain in relation to the direction of woodworking operations. In this work, up-milling (conventional cutting) was applied, as well as two woodworking techniques: with the grain and against the grain. Tests were conducted on samples differing in their position at the stem cross-section, one located closer to the circumference with the spiral grain angle of 11.5° and the other located closer to the pith, in which the spiral grain angle was 7.5°. This analysis confirmed significant differences in cutting power recorded for different values of spiral grain angle and depending on the applied cutting techniques. Cutting power at milling with the grain was greater than at milling against the grain. For samples with a smaller spiral grain angle a lower cutting power was recorded than for samples with a greater spiral grain angle. Differences in cutting power requirement between milling with the grain and against the grain increase with an increase in spiral grain angle.
| Reference Key |
pinkowski2016bioresourcesthe
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Grzegorz Pinkowski;Andrzej Krauss;Maciej Sydor |
| Journal | medical archives (sarajevo, bosnia and herzegovina) |
| Year | 2016 |
| DOI |
10.15376/biores.11.4.9302-9310
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.