precise hole drilling in pmma using 1064 nm diode laser cnc machine
Clicks: 301
ID: 131388
2011
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Star Article
30.0
/100
301 views
29 readers
AI Quality Assessment
Not analyzed
Readership in this journal
StarRanked #16 of 254 articles by views in bulletin of the korean chemical society
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 254 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper represents the outcome of efforts that intended to achieve laser hole drilling execution in polymethylmethacrylate (PMMA) of 2.5 mm thickness using 1064 nm diode laser of 5 W output power. Different laser beam powers, exposure time, and positions of the laser spot were taken into consideration with respect to the workpiece. The workpieces were tested in the existence of low-pressure assist gas (20–60 mmHg of air). The experimental results were supported by the predicted results of the analytical model.
| Reference Key |
abdulnabi2011advancesprecise
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Jinan A. Abdulnabi;Thaier A. Tawfiq;Anwaar A. Al-Dergazly;Ziad A. Taha;Khalil I. Hajim |
| Journal | bulletin of the korean chemical society |
| Year | 2011 |
| DOI |
10.1155/2011/137407
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.