improving the machining process by analysing the relationship between cutting force and temperature in drilling of engineering steels
Clicks: 167
ID: 130916
2016
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Steady Performance
30.0
/100
167 views
13 readers
AI Quality Assessment
Not analyzed
Readership in this journal
SteadyRanked #286 of 391 articles by views in Talanta
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 391 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
This paper describes the experiment of measuring the temperature and cutting force during the drilling of short holes without using cutting lubricants, at constant cutting speed, and at increasing shift. Measurement was performed on steel samples of grade 11 523. During drilling, temperature was monitored by a thermocouple, using the method of two foreign metals. Cutting force was measured by a strain-gauge sensor. The experiment provides a quick orientation in the given issue and points out to the optimisation of cutting conditions. Based on results, it can be stated that the range of temperatures and the size of cutting forces depends on technological conditions, cutting parameters, and mechanical and physical properties of tool and workpiece’s material.
| Reference Key |
polk2016actaimproving
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | ;Pavel Polák;Zuzana Poláková;Ján Žitňanský;Petr Dostál;Katarína Kollárová |
| Journal | Talanta |
| Year | 2016 |
| DOI |
10.11118/actaun201664030855
|
| URL | |
| Keywords | Keywords not found |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.