Early Stages of Plastic Deformation in Low and High SFE Pure Metals

Clicks: 295
ID: 119770
2020
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Steady

Ranked #20 of 66 articles by views in metals

Most read Least read

Bar heights use a square-root scale.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Severe plastic deformation (SPD) techniques are known to promote exceptional mechanical properties due to their ability to induce significant grain and cell size refinement. Cell and grain refinement are driven by continuous newly introduced dislocations and their evolution can be followed at the earliest stages of plastic deformation. Pure metals are the most appropriate to study the early deformation processes as they can only strengthen by dislocation rearrangement and cell-to-grain evolution. However, pure metals harden also depend on texture evolution and on the metal stacking fault energy (SFE). Low SFE metals (i.e., copper) strengthen by plastic deformation not only by dislocation rearrangements but also by twinning formation within the grains. While, high SFE metals, (i.e., aluminium) strengthen predominantly by dislocation accumulation and rearrangement with plastic strain. Thence, in the present study, the early stages of plastic deformation were characterized by transmission electron microscopy on pure low SFE Oxygen-Free High Conductivity (OFHC) 99.99% pure Cu and on a high SFE 6N-Al. To induce an almost continuous rise from very-low to low plastic deformation, the two pure metals were subjected to high-pressure torsion (HPT). The resulting strengthening mechanisms were modelled by microstructure quantitative analyses carried out on TEM and then validated through nanoindentation measurements.
Reference Key
cabibbo2020metalsearly Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Marcello Cabibbo;Eleonora Santecchia;Cabibbo, Marcello;Santecchia, Eleonora;
Journal metals
Year 2020
DOI
10.3390/met10060751
URL
https://doi.org/10.3390/met10060751
Keywords
tem strengthening plastic deformation hpt pure al pure cu

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.