FPGA-based multiprocessor system for injection molding control
Clicks: 208
ID: 114671
2012
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This
article has not been analysed, so there is no overall score —
reader engagement is measured and shown alongside.
Reader Engagement
Popular Article
30.0
/100
208 views
36 readers
AI Quality Assessment
Not analyzed
Readership in this journal
PopularRanked #1,337 of 1,694 articles by views in sensors
Most read
Least read
Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 1,694 in total.
Mint this article as an NFT
Not yet mintedCreate a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.
5
SUSD
one-off · no wallet required
Abstract
The plastic industry is a very important manufacturing sector and injection molding is a widely used forming method in that industry. The contribution of this work is the development of a strategy to retrofit control of an injection molding machine based on an embedded system microprocessors sensor …
Abstract Quality Issue:
This abstract appears to be incomplete or contains metadata (47 words).
Try re-searching for a better abstract.
| Reference Key |
b2012sensorsfpga-based
Use this key to autocite in the manuscript while using
SciMatic Manuscript Manager or Thesis Manager
|
|---|---|
| Authors | Muñoz-Barron B;Morales-Velazquez L;Romero-Troncoso RJ;Rodriguez-Donate C;Trejo-Hernandez M;Benitez-Rangel JP;Osornio-Rios RA;; |
| Journal | sensors |
| Year | 2012 |
| DOI |
DOI not found
|
| URL | |
| Keywords |
Citations
No citations found. To add a citation, contact the admin at info@scimatic.org
Comments
No comments yet. Be the first to comment on this article.