Silver Nanowires on Carbon Nanotube Aerogel Sheets for Flexible, Transparent Electrodes.

Clicks: 317
ID: 11398
2019
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #124 of 899 articles by views in ACS applied materials & interfaces

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 899 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
Flexible, free-standing transparent conducting electrodes (TCEs) with simultaneously tunable transmittances up to 98% and sheet resistances down to 11 Ω/sq were prepared by a facile spray-coating method of silver nanowires (AgNWs) onto dry-spun multiwall carbon nanotube (MWNT) aerogels. Counterintuitively, the transmittance of the hybrid electrodes can be increased as the mass density of AgNWs within the MWNT aerogels increases, however, the final achievable transmittance depends on the initial transparency of the MWNT aerogels. At the same time, a strong decrease in sheet resistance is obtained when AgNWs form a percolated network along the MWNT aerogel. Additionally, anisotropic reduction in sheet resistance and polarized transmittance of AgNW/MWNT aerogels is achieved with this method. The final AgNW/MWNT hybrid TCEs transmittance and sheet resistance can be fine-tuned by spray-coating mechanisms or by the choice of initial MWNT aerogel density. Thus, a wide range of AgNW/MWNT hybrid TCEs with optimized optoelectronic properties can be achieved depending of the requirements needed. Finally, the free-standing AgNW/MWNT hybrid TCEs can be laminated onto a wide range of substrates without the need of a bonding aid.
Reference Key
martinez2019silveracs Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Martinez, Patricia M;Ishteev, Arthur;Fahimi, Azin;Velten, Josef;Jurewicz, Izabela;Dalton, Alan B;Collins, Steve;Baughman, Ray H;Zakhidov, Anvar A;
Journal ACS applied materials & interfaces
Year 2019
DOI
10.1021/acsami.9b06368
URL
Keywords Keywords not found

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.