FPGA-Based Multiprocessor System for Injection Molding Control

Clicks: 234
ID: 112001
2012
Free PDF
Article Quality & Performance Metrics
Overall Quality
Not rated
Combines reader engagement with the AI quality analysis. This article has not been analysed, so there is no overall score — reader engagement is measured and shown alongside.
AI Quality Assessment
Not analyzed
Readership in this journal
Emerging

Ranked #1,146 of 1,694 articles by views in sensors

Most read Least read

Bar heights use a square-root scale. Only the 120 most-read articles are drawn; the journal has 1,694 in total.

Mint this article as an NFT
Not yet minted

Create a permanent, verifiable on-chain record of this article on the Scimatic Network. The NFT is held in your Journament account, and you can withdraw it to your own wallet at any time.

5 SUSD one-off · no wallet required
Sign in to mint
Abstract
The plastic industry is a very important manufacturing sector and injection molding is a widely used forming method in that industry. The contribution of this work is the development of a strategy to retrofit control of an injection molding machine based on an embedded system microprocessors sensor network on a field programmable gate array (FPGA) device. Six types of embedded processors are included in the system: a smart-sensor processor, a micro fuzzy logic controller, a programmable logic controller, a system manager, an IO processor and a communication processor. Temperature, pressure and position are controlled by the proposed system and experimentation results show its feasibility and robustness. As validation of the present work, a particular sample was successfully injected.
Reference Key
muñoz-barron2012sensorsfpga-based Use this key to autocite in the manuscript while using SciMatic Manuscript Manager or Thesis Manager
Authors Benigno Muñoz-Barron;Luis Morales-Velazquez;Rene J. Romero-Troncoso;Carlos Rodriguez-Donate;Miguel Trejo-Hernandez;Juan P. Benitez-Rangel;Roque A. Osornio-Rios;Muñoz-Barron, Benigno;Morales-Velazquez, Luis;Romero-Troncoso, Rene J.;Rodriguez-Donate, Carlos;Trejo-Hernandez, Miguel;Benitez-Rangel, Juan P.;Osornio-Rios, Roque A.;
Journal sensors
Year 2012
DOI
10.3390/s121014068
URL
https://www.mdpi.com/1424-8220/12/10/14068##abstractc
Keywords
sensor network fpga smart-sensor plastic injection molding National Center for Biotechnology Information NCBI NLM MEDLINE pubmed abstract nih national institutes of health national library of medicine research support non-u.s. gov't pmid:23202036 pmc3545607 doi:10.3390/s121014068 benigno muñoz-barron luis morales-velazquez roque a osornio-rios

Citations

No citations found. To add a citation, contact the admin at info@scimatic.org

Comments

No comments yet. Be the first to comment on this article.